rear axel seal – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 2 replies, 3 voices, and was last updated February 11, 2020 at 5:29 pm by Gary and Diana Holman.

Viewing 2 reply threads

Author

Posts
- January 15, 2019 at 6:46 pm #58619
  cuppy65
  Has any here pulled a hub from a 63 S2 car . Rear seal? The nut came off and I heated it real good and I have a good puller but I can’t get it to budge?
  Also , my motor has a aluminum head , is that anything abnormal?
  Thanks all
- January 18, 2019 at 3:48 pm #67178
  Ron & Linda Jones
  Participant
  I’m having the same problem.
- February 11, 2020 at 5:29 pm #78129
  Gary and Diana Holman
  Participant
  I guess you guys already found the answers, but yes alpines had aluminum heads and the rear axle hub is a pain with the method being to heat and beat. Most advanced and autozone have the puller to loan you, do not attempt removing the hub without a puller. Even with a puller and lots of heat sometimes the hub gets bent, but can be fixed. Always use anti seize when you reassemble them.
Author

Posts

Viewing 2 reply threads

You must be logged in to reply to this topic.