Hardtop Rubber Seals – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 1 reply, 2 voices, and was last updated August 18, 2014 at 1:49 pm by mikephillips.

Viewing 1 reply thread

Author

Posts
- August 15, 2014 at 9:05 pm #58196
  Byron & Carolyn Golfin
  Participant
  On the door window horizontal seal (HT60), does the open side of the seal face outward or in toward the inside of the car.
  
  On the hardtop to body seal (HT61), the rubber flap on one side of the retainer that goes into the metal channel is wider than the other side. Does the wider flap face the outside or inside of the car.
  
  These pieces will fit both ways and I cannot tell from the drawing in SS catalog.
- August 18, 2014 at 1:49 pm #65792
  mikephillips
  For HT60, the curve section is towards the car so that the glass will go up into the V formed by the two sides.
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.