Clutch release push rod length – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 0 replies, 1 voice, and was last updated August 31, 2009 at 10:43 am by gary.

Viewing 0 reply threads

Author

Posts
- August 31, 2009 at 10:43 am #57444
  gary
  Hi Folks,
  I am replacing the clutch in a SV and now realise that I have the earlier series adjustable rod between the slave cylinder and clutch release arm. it has been adjusted to it’s maximum length.
  
  My question is how long should the fixed length SV rod be? My concern is that with a new bearing and clutch this rod is probably adjusted to be too long.
  
  Thanks
  
  Gary
Author

Posts

Viewing 0 reply threads

You must be logged in to reply to this topic.