Balljoint taper? – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 1 reply, 1 voice, and was last updated February 15, 2011 at 4:42 pm by pererik69.

Viewing 1 reply thread

Author

Posts
- January 6, 2011 at 4:20 pm #57654
  pererik69
  Anybody know the exact figure of degrees taper on the lower balljoints in the front suspension? I need to cut the taper in a nonstock spindle, and I find it hard to measure the exact value.
  
  Best regards,
  
  Per Erik
- February 15, 2011 at 4:42 pm #63939
  pererik69
  If anybody else need this information, its 7.2 degrees.
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.