I did meet with Doug and we talked about the repairs needed. I actually (almost) had him talked into helping me with it. But retirement is really more important and I’m sure he is enjoying it. Our plan was to make a jig using the other Tiger and then putting the damaged Tiger on it. Then building the damaged one to fit the jig. If you know the car, it is a good candidate for the repair because the balance of the car is rust free. When I first saw the pictures I thought that everything looked so clean, I couldn’t pass it up. I have the skills to make a rail(time is the issue), however at age 57 it would be easier to stub in a correct rail. I am open to someone else doing this repair, perhaps someone who has more Tiger experience than I. I am located in the Madison, WI area.
Forums
All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below