Rear axle hub gaskets – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 1 reply, 1 voice, and was last updated April 9, 2021 at 9:59 pm by Jeffrey Smith.

Viewing 1 reply thread

Author

Posts
- April 2, 2021 at 5:46 pm #84949
  Jeffrey Smith
  Greetings, looking for sequence of components on the Tiger rear axle. Reading an old manual for the Salisbury 4ha, it appears that the sequence from the axle tube out would be shim,brake backing plate, gasket, bearing plate, gasket, and oil seal retainer. Can anyone confirm? Thanks, Jeff
- April 9, 2021 at 9:59 pm #85027
  Jeffrey Smith
  Just figured I’d post this in case anyone needs it. After a bit of research and a few emails, the sequence from the axle tube out is– end float shim, paper gasket, brake backing plate, paper gasket, bearing retainer, seal housing.
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.