As the manual usually says, just the reverse of taking it out.
I lay the cross tube in loosel then the tubing and elbows, followed by the tanks.
Make sure you have the cross balancing vent tube in beforehand, the tube which connectes both tanks on top.
The hardest part is to get this vent tube and the filler tube connected and tightened withe the filler cap. Tighten all tubes and connect the fuel line to the pump next.
Robert
Forums
All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below 