All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below
-
-
Can someone Please post pictures of the lower grille molding position and how it clipped on a Tiger MK1A ?
Thanks
Steve
Edit/Delete Message
-
I don’t have a picture so I’ll try to describe it. If you look at the flat area of the grille opening you should see 4 holes or rivets that look like small cups if they haven’t been removed. the lower finisher pops over top of them following the holes from side to side meeting the chrome eyebrow that outlines the sides and upper part of the opening. If the rivets have been removed, Sunbeam Specialties I believe has them, look in the catalog for the lower finisher and they should be listed with it.
-
Steve – I can take a couple of pix of one installed on the car – would that help? Car is inside (8 degrees here and snow covered), I should be able to get something…
-
Mark,
Thanks that would be great if you could get a couple of pic. Don’t stay out to long in the -8. 😀
Steve
-
You can see the trim in this photo.
-
-
Thanks Mark, that helped alot. 😀 😀 😀
-
Well, that wasn’t me – but glad that you got what you needed. Nice response from our members 🙂
I tried to take a shot from underneath, but with the undercoat on my car the photo was pretty well useless.
-
Both cars shown are restorations done by Doug Jennings. He installed both lower finishers
Bob
-
Sorry about that Bob and Mark for the mix up. 😳 Thanks for the post they Help a lot.
- You must be logged in to reply to this topic.
.
