Windshield frame to cowl seal installation

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 1 reply, 2 voices, and was last updated May 13, 2013 at 3:07 pm by mikephillips.

Viewing 1 reply thread

Author

Posts
- May 13, 2013 at 1:02 pm #58007
  Jay Silverberg
  I bought the new seal from Rick and it came with instructions that attempt to save some installation frustration by advising how to pre-glue the seal in place. However, it’s not clear to me where exactly I should be gluing the round bulb (bottom of the T shaped cross section).
  Does this bulb actually reside inside the windshield, visible from inside the car when the windshield is installed? Or does it sit underneath the frame, out of sight? I googled and searched, and came up empty. Thanks.
- May 13, 2013 at 3:07 pm #65136
  mikephillips
  Goes on the inside, really not that noticable against the black dash top. You’ll need to cut a small section out where the center stud is.
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.