Holes for Tiger trim – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 1 reply, 2 voices, and was last updated February 8, 2005 at 8:25 pm by hugh-guynes.

Viewing 1 reply thread

Author

Posts
- February 7, 2005 at 2:59 pm #56315
  Peter & Penny Stanisavljevich
  Can anybody supply measurements for the body holes for the little piece of stainless trim ahead of the doors on the front fenders of a Tiger? There are two holes, and a distance from the front fender at the door gap edge for both would be a big help.
- February 8, 2005 at 8:25 pm #58718
  hugh-guynes
  1.4 in. from the back edge of the fender and 1.4 in. between holes.
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.