Page 1 of 1

parts

Posted: Tue Sep 26, 2017 12:39 pm
by klassixplus
I sold my Tiger and have a lot of parts I hope someone can use 2 Tiger 260 engines rear end hard top wood dash full set of reconditioned gauges nose trunk L quarter hoods doors seats and tracks gas tanks valve covers latches lot of rubber parts and too many small parts to list thanks Larry

Re: parts

Posted: Tue Sep 26, 2017 1:18 pm
by TAH_Tiger
Larry-
Where are you located?

Re: parts

Posted: Wed Sep 27, 2017 6:57 am
by VaCat33
Larry

What are the casting codes, casting date codes and build date for the engines.

If you do not know, the casting codes are down on the right (passenger) lower side of the block. The build date is stamped into the small pad on the front/left side of the block.

Thanks

Jim

Re: parts

Posted: Wed Sep 27, 2017 4:28 pm
by CLEVITE
How much for the dash?

Fred Baum

Re: parts

Posted: Mon Oct 02, 2017 7:04 pm
by gbyxbee
Would be interested in a hood ... where are you? Thanks!

Re: parts

Posted: Mon Oct 09, 2017 4:08 pm
by klassixplus
TAH_Tiger wrote:Larry-
Where are you located?

I am in Lenoir NC 828 295 6362 thanks Larry

Re: parts

Posted: Mon Oct 09, 2017 4:09 pm
by klassixplus
CLEVITE wrote:How much for the dash?

Fred Baum

Make offer 828 295 6362 thanks Larry

Re: parts

Posted: Mon Oct 09, 2017 4:10 pm
by klassixplus
gbyxbee wrote:Would be interested in a hood ... where are you? Thanks!

I am in Lenoir NC 828 295 6362 thanks Larry

Re: parts

Posted: Mon Oct 09, 2017 4:19 pm
by klassixplus
VaCat33 wrote:Larry

What are the casting codes, casting date codes and build date for the engines.

If you do not know, the casting codes are down on the right (passenger) lower side of the block. The build date is stamped into the small pad on the front/left side of the block.

Thanks

Jim

The casting #s are C40E-6015E and 040F-6015F I don,t see the front ones 828 295 6362 thanks Larry

Re: parts

Posted: Thu Oct 12, 2017 10:26 am
by mikephillips
The flat with the build date is to the right of the distributor by the cylinder head front as you face the engine from the front. However if the block has been decked in the past it could have been ground off leaving just a flat spot.

Re: parts

Posted: Sun Nov 12, 2017 8:43 pm
by TigerFogie
I'm interested in the dash, gauges and rocker covers. Do you have a price in mind for these?