parts
Moderator: 65sunbeam
Forum rules
FOR SALE items will be listed for 6 months after the last post.
After 6 months time, they will be pruned off the list.
(If your item is still for sale, just post a reply that it is, and it will stay active.)
Consider reaching the whole TEAE audience and post your FOR SALE ad in the Rootes Review.
Contact the editor by email:
editor <at> teae.org
FOR SALE items will be listed for 6 months after the last post.
After 6 months time, they will be pruned off the list.
(If your item is still for sale, just post a reply that it is, and it will stay active.)
Consider reaching the whole TEAE audience and post your FOR SALE ad in the Rootes Review.
Contact the editor by email:
editor <at> teae.org
-
- Silver
- Posts: 5
- Joined: Tue Sep 26, 2017 12:09 pm
- Club Member of TEAE?: No
parts
I sold my Tiger and have a lot of parts I hope someone can use 2 Tiger 260 engines rear end hard top wood dash full set of reconditioned gauges nose trunk L quarter hoods doors seats and tracks gas tanks valve covers latches lot of rubber parts and too many small parts to list thanks Larry
Re: parts
Larry
What are the casting codes, casting date codes and build date for the engines.
If you do not know, the casting codes are down on the right (passenger) lower side of the block. The build date is stamped into the small pad on the front/left side of the block.
Thanks
Jim
What are the casting codes, casting date codes and build date for the engines.
If you do not know, the casting codes are down on the right (passenger) lower side of the block. The build date is stamped into the small pad on the front/left side of the block.
Thanks
Jim
-
- Silver
- Posts: 5
- Joined: Tue Sep 26, 2017 12:09 pm
- Club Member of TEAE?: No
Re: parts
TAH_Tiger wrote:Larry-
Where are you located?
I am in Lenoir NC 828 295 6362 thanks Larry
-
- Silver
- Posts: 5
- Joined: Tue Sep 26, 2017 12:09 pm
- Club Member of TEAE?: No
Re: parts
CLEVITE wrote:How much for the dash?
Fred Baum
Make offer 828 295 6362 thanks Larry
-
- Silver
- Posts: 5
- Joined: Tue Sep 26, 2017 12:09 pm
- Club Member of TEAE?: No
Re: parts
gbyxbee wrote:Would be interested in a hood ... where are you? Thanks!
I am in Lenoir NC 828 295 6362 thanks Larry
-
- Silver
- Posts: 5
- Joined: Tue Sep 26, 2017 12:09 pm
- Club Member of TEAE?: No
Re: parts
VaCat33 wrote:Larry
What are the casting codes, casting date codes and build date for the engines.
If you do not know, the casting codes are down on the right (passenger) lower side of the block. The build date is stamped into the small pad on the front/left side of the block.
Thanks
Jim
The casting #s are C40E-6015E and 040F-6015F I don,t see the front ones 828 295 6362 thanks Larry
-
- Silver
- Posts: 158
- Joined: Tue May 10, 2005 1:17 pm
- Club Member of TEAE?: Yes
- Membership Number: 1412
Re: parts
The flat with the build date is to the right of the distributor by the cylinder head front as you face the engine from the front. However if the block has been decked in the past it could have been ground off leaving just a flat spot.
-
- Silver
- Posts: 7
- Joined: Sun Nov 12, 2017 8:34 pm
- Club Member of TEAE?: Yes
- Membership Number: 2425
Re: parts
I'm interested in the dash, gauges and rocker covers. Do you have a price in mind for these?
Who is online
Users browsing this forum: Bing [Bot] and 1 guest