lower control arm bushings and shafts

Post information regarding the modification of Tigers.
jkirchne
Silver
Silver
Posts: 21
Joined: Thu Aug 24, 2006 9:52 pm

lower control arm bushings and shafts

Postby jkirchne » Fri Jan 05, 2007 5:58 pm

I have global west control arm bushings and shafts; the problem I am having is the global west’s instructions contradict the shop manual (the shaft installation and spacing is different than the manual). Global west is no help they haven’t made this setup for ten years. I the Tiger shop manual in section F page 22 it states in bold print "IT IS VITALLY IMPORTANT THAT THE FULCRUM PIN IS FITTED SO THAT THE GREATER DIMENSION IS TO THE REAR ARM OF THE LINK"

I think that Global west messed up on there instructions, any help would be appreciated.

Thanks

Jim K

John Logan
Silver
Silver
Posts: 105
Joined: Sun Jan 30, 2005 11:15 am
Club Member of TEAE?: No
Location: Dearborn, MI

Postby John Logan » Sat Jan 06, 2007 9:54 am

Tim,

Go with the manual instructions. John Logan


Return to “Modified Tiger”

Who is online

Users browsing this forum: No registered users and 1 guest